Table of Contents
Advertisement
_äÉåÇmolJff=oÉ~ê=m~åÉä
The figure below illustrates the BlendPRO-II rear panel:
INPUTS
1
2
5
Figure 2-1. BlendPRO-II Rear Panel
1)
Genlock In
2)
Widescreen Lock Out
3)
Serial Port
4)
AC Connector
Following are descriptions of each rear panel connector and section:
1)
2)
BlendPRO-II • User's Guide
1
2
GENLOCK
WIDESCREEN LOCK
IN
OUT
1
3
4
1
Genlock In
One BNC connector is provided for a Genlock Input, which can be used to lock
BlendPRO-II and its associated ScreenPro-II inputs to an external source if
desired. Please note:
~
BlendPRO-II can genlock to Composite bi or tri-level syncs.
~
Similarly, black burst type syncs can be used within the limitations of the
BlendPRO-II input resolutions.
~
Because BlendPRO-II does not contain a loop-through connector, the
incoming sync will be terminated to 75 Ohms.
Widescreen Lock Out
One BNC connector is provided for a Widescreen Lock Output, which is
required to supply H and V sync locking information to each ScreenPro-II
GENLOCK input, as well as communicate various widescreen synchronization
commands via a proprietary interface.
Important
This connector is not a loop-through, and can only be used
with BlendPRO-II and ScreenPRO-II systems.
2. Hardware Orientation
OUTPUTS
2
3
2
3
6
5)
Inputs Section
6)
Outputs Section
7)
Ethernet Port
BlendPRO-II Rear Panel
3
4
SERIAL
4
ETHERNET
4
100-240 V
50-60 Hz
2.3 A
7
17
Advertisement
Table of Contents
