Driver Installation - Barco Coronis 3MP Installation & User Manual

checkbox next to it. When you have finished selecting the
BarcoMed Software you wish to install, click "Install" on the
Wizard's Welcome Screen to continue or "Cancel" to exit the
wizard.

Driver Installation

5. Click "Next" on the Display Driver Wizard's Welcome Screen to
continue or "Cancel" to exit the Display Driver Wizard and return
to the Software Install Wizard.
6. The Device Selection Screen (figure 6 below) shows the devices
supported by the driver on the CD. Under Windows NT the wizard
does not detect the physical hardware installed in the computer.
Since Windows NT supports only one type of video device at a
time, you may choose only one type of device to install. After you
have selected the device you want to install, click "Next".
If you selected a device with an existing driver, the Wizard will
warn you if the current driver is newer than the one you are
installing (see figure 7 below).
If you want to change your selection, click "OK" to continue and
then click "Back" on the next screen otherwise click "OK".
System manual Coronis 3MP
BarcoMed software driver installation
Figure 6
Figure 7
49