Maintenance; Troubleshooting - Axminster AWFS18 User Manual

3. The motor is permanently lubricated. Do not try to oil the motor bearings or service any internal parts of the
motor. If the power cord is worn, frayed, cut or damaged, contact Axminster Power Tool Centre. Do not try to patch
it up with electrical tape, this could lead to more trouble.
Fig 20
To gain access to the drive bearings, remove the
side panel by undoing the Philips screw,
counter-clockwise.
4. Frequently blow out any dust that may accumulate inside the motor. An occasional
light coat of oil on the table to prevent surface rust is recommended.
5. Occasionally wipe the machine over with a damp cloth.
6. If the fretsaw is not going to be used for a period of time, smear a light coat of oil over the work table and place
a dust sheet over the fretsaw. (Part no: 600410).
PROBLEM
Breaking Blades
Motor Will Not Run
Excessive Vibration
(Some vibration is inevitable when the
saw and motor are running)
Blade Runout
(Blade not in line with motion
of Rocker Arms).
Lower arm
PROBABLE CAUSES
1. Incorrect tension.
2. Overworked (worn out) blade.
3. Wrong blade being used.
4. Twisting blade in wood.
1. Defective cord, plug or outlet
2. Defective motor.
1. Improper mounting of saw.
2. Unsuitable mounting surface.
3. Loose table.
4. Motor mount is loose.
1. Blade clamps not aligned.
21
Once you have removed side panel
lubricate the lower arm/drive bearing
with 3-IN-ONE oil.

Troubleshooting

SUGGESTED REMEDY
1 Adjust blade tension.
2. Reduce feed rate or replace blade.
3. Use narrow blades for thin wood,
wider blades for thicker wood.
4. Avoid side pressure on blade.
1. Unplug saw, replace defective parts.
2. Repairs MUST be made by a
qualified technician. Call Axminster
Tool Centre. (Technical Sales
Phone: 08700 600388).
1. See proper mounting instructions.
2. Replace plywood workbench
surface with solid lumber surface.
3. Tighten table clamping knob.
4. Tighten motor mount screws.
1. Loosen the blade clamping knob (F).
Adjust position of blade clamps. Use a
90˚ square to verify alignment.
Re-tighten clamping knob (F) &
continue operation.

Maintenance

Fig 21
OIL