Mounting The Scroll Saw - Axminster AWFS18 User Manual

3) Grasp the plastic air hose on the fretsaw (A) and
push it onto the 1/4" BSP brass fitting until it's fully
home. (See fig 10).
4) Finally connect the Male & Female in line connectors
from the motor and NVR switch assembly together.
(See fig 11).
Your scroll saw is provided with three threaded
mounted holes (A), see fig 12, it is strongly
recommended that you mount the machine to a
workbench (See fig 12a) or to a purpose built Fretsaw
stand. (See fig 12b) (Part No: 100082). A pad between
the saw and the workbench/stand is also
recommended to reduce vibration. The
workbench/stand should be at least 250 x 410mm.
Fig 12
A
B
Fig 12a
SCROLL SAW
Ensure you use flat washers between the bolt head and
mounting holes. (DO NOT OVERTIGHTEN) There are
two extra holes (B) for added stability if required.
NOTE: Fretsaw Stand Only. You may need to add a
larger sub-table (MDF or Plywood plate) to give
extra support to larger models.
09
Initial Assembly
Fitting the Air Delivery Tube:
Female
Male

Mounting the Scroll Saw

B
A
Fig 12b
(Part No: 100082)
Fig 11