Avocent MERGEPOINT SP MANAGER Installer/User Manual page 26

MergePoint® SP Manager Installer/User Guide
14
2. Start a session with the port settings of serial speed as 9600 bps, data length as 8 data bits,
parity as none, stop bits as 1, flow control as none and emulation as ANSI.
Once a connection is established, a prompt appears.
3. Enter the username and password. The preset values is
password.
4. For the MergePoint SP5x00 manager:
a. Type
b. Type a number from
your network. For example, type
NOTE: If you wish to restore the default configuration parameters, enter 8 from the top-level menu.
-or-
For a MergePoint SP5x24/SP5x40 manager:
a. Log into the console port as
b. Enter the
c. Type
d. Configure the primary Ethernet interface (eth0) by setting the method to static and
assigning a static IP address, a gateway and a netmask:
cli> set network interface eth0 method static address
<SPmanager_IPaddress> gateway <gateway_IP_address> netmask
<netmask>
e. Specify a hostname, a domain, a DNS server IP address, and an optional secondary
DNS server IP address:
cli> set network hostname <appliance_name> resolv domain
<domain_name> dns0 <DNS_server_IPaddress> dns1 <secondary_DNS_
server_IPaddress>
f. Confirm the configuration for the interface:
cli> get network interface eth0
g. Confirm the name server configuration:
cli> get network resolv
h. Save the changes:
cli> commit
(Network Config).
2
to to configure the corresponding network settings specific to
1 5
passwd command, and enter and confirm a new password for the root user.
cli to load the CLI utility.
to config eth0 IPv4; type
1
root with the default password
for both the username and
admin
to config eth1 IPv4.
3
Sydney .