Avocent MERGEPOINT SP MANAGER Installer/User Manual page 140

MergePoint® SP Manager Installer/User Guide
128
processor user, you must enter
configured after adding, using the
Table 7.2: Parameters that Work with the CLI add Command
Parameter
Level 1
dhcpd
iptables
network
add spmanager user <username>
set
Parameter
What It Configures (Syntax)
Level 2
Add a MAC address for IP.
Synopsis: add adhpd mapping <MAC_address>
Example: add dhcpd mapping 00602e01d9a6
mapping
NOTE: No colon (:) is needed in the MAC address.
See the set command for the following parameters: dhcpd setting subnet on page 138,
dhcpd setting relay on page 138 and dhcpd mapping on page 138.
Firewall configuration. Add a new rule to NAT table and filter table.
Synopsis: add iptables nat [PREROUTING|POSTROUTING|OUTPUT] <number>|
nat | filter
filter [INPUT|OUTPUT|FORWARD] <chainname> <number>
Example: add iptables nat PREROUTING 0
Add an alias to an interface.
interface Synopsis: add network interface <interface> alias <alias_name>
Example: add network interface eth1 alias yd
Add an IP address for a host.
hosts Synopsis: add network hosts <IPaddress>
Example: add network hosts 172.26.25.178
Add to the list of static route targets a subnet or host (networks in the form 1.2.3.0/24 or
host IPs).
st_routes Synopsis: add network st_routes <network_IPaddress/netmask> | <host_
IPaddress>
Example: add network st_routes 1.1.1.1
command.
; the user must then be