Avocent MERGEPOINT SP MANAGER Installer/User Manual page 177

Managing power or rebooting a managed server
Manage power or reboot a managed server by entering either stop, reset or start with the
/admin1/system[n] target.
To power off a managed server:
Enter the stop command followed by the target name for the managed server.
/admin1-> stop /system2
To reset a managed server:
Enter the reset command followed by the target name for the managed server.
/admin1-> reset /system3
To start a managed server:
Enter the start command followed by the target name for the managed server.
/admin1-> start /system3
Checking sensors on managed servers
You can check sensor data on managed servers using the show command with the
/admin1/system[n]/sensor[n] target.
To check sensor data on an managed server:
Enter the show command followed by the /admin1/system[n]/sensor[n] target.
/admin1-> show /system3/sensor1
/system3/sensor1
properties
SystemName = 172.26.25.122
OperationalStatus =
RequestedState = 5 (No Change)
EnabledState = 5 (Not Applicable)
HealthState = 0 (Unknown)
ElementName = ROMB Battery
CurrentState = N/A
SensorType = 3 (Voltage)
PossibleStates =
CreationClassName = AVCT_DiscreteSensor
SystemCreationClassName = 172.26.25.122:AVCT_DiscreteSensor
DeviceID = 32:0:17
verbs
cd
Chapter 8: Using SMASH Command Line Protocol 165