Selecting Target Devices For Scan Mode; Figure 3.12: Oscar Interface Commands Dialog Box - Avocent AUTOVIEW 3008 Installer/User Manual

26 AutoView 3008/3016 Switch Installer/User Guide
Table 3.6: Commands to Manage Routine Tasks for Your Target Devices (Continued)
Features
Display Versions View version information for the AutoView 3008/3016 switch as well as view and upgrade
Display Config
Device Reset
To access the OSCAR interface Commands dialog box:
Activate the OSCAR interface and click Commands to open the dialog box shown in Figure 3.12.

Figure 3.12: OSCAR Interface Commands Dialog Box

Selecting target devices for Scan mode

The Scan dialog box allows the local user to define a custom list of servers to include while in Scan
mode and the number of seconds to display each server. The creation of the Scan list does not start
Scan mode. You must enable Scan mode via the Scan Enable checkbox on the Commands dialog
box. The Scan list is displayed in the manner set from the Menu dialog box. It can be changed in the
Scan dialog box to sort either by Name, EID or Port by choosing one of the buttons. If a server on
the list is unavailable, it is skipped. Watch mode views a server unless a conflicting network user
blocks the path to that server. If a conflict is detected in Watch mode (or the server is unavailable),
the server to be viewed is skipped.
To add target devices to the Scan list:
1. Activate the OSCAR interface and click Setup - Scan to open the Scan dialog box.
Purpose
firmware for individual IQ modules.
View current configuration parameters.
Re-establish operation of PS/2 keyboard and mouse on the local port.