Operation In Online Mode - Avery Dennison AP4.4 User Manual

05/09 Rev. 5.02-01

Operation in Online Mode

USER MANUAL
AP4.4 – AP5.4
•
Feed material until the next punch is reached or as long as the button is
held down:
OFFLINE x JOBS
•
Setting the label length automatically:
OFFLINE x JOBS
After pressing the two buttons, the printer feeds the label material, until two
punches have passed the label sensor. The measured label length then
will be displayed and saved into parameter
Material length. Furthermore, parameter
be set to „punched".
Display of the measured label length:
OFFLINE x JOBS
198.5 mm
The label length measured by this function regards the label without the
following punch, what means from label end to label end. If label stock with
very large punches is used, this measurement will not work properly. In this
case, it is adviseable to measure and set the label length manually (label
length + punch length).
•
Switching to offline mode:
ONLINE x JOBS
•
Setting the print contrast: Press the Feed button to increase and the Cut
button to decrease the print contrast.
ONLINE x JOBS
•
Interrupting the print job: The device will finish printing the current label.
ONLINE X JOBS
Restcount XXX
a) The message "Stopped
•
Switching to offline mode while the print job is stopped:
ONLINE X JOBS
Stopped XXX
•
Continuing the print job:
ONLINE X JOBS
Stopped XXX
Feed
Feed Prog
PRINT PARAMETERS >
PRINT PARAMETERS > Material type
Online
Prog
Prog
xxx" alternates with "Press Feed".
Online
Feed
Setup & Operation
OFFLINE x JOBS
feeding...
OFFLINE x JOBS
Manual Calibrate
will
OFFLINE x JOBS
Print contrast
xxx%
ONLINE X JOBS
a
Stopped XXX
OFFLINE x JOBS
ONLINE X JOBS
Restcount XXX
22