Activate/Deactivate Dispenser - Avery Dennison AP4.4 User Manual

05/09 Rev. 5.02-01
Possible Errors
Shortly after activating the internal rewinder, the following error message may
be displayed:
Possible causes:
The printer is now ready for the next print job. As soon as the print job is re-
ceived, the rewinder's control electronics analyse the material width and print
speed as specified by the print job and calculate basic initialisation settings for
the rewinding process. These settings cover most areas of application.
In some challenging applications, a reduced impression accuracy may occur.
In cases like these, the basic initialisation settings can be changed. This may
be necessary in the case of:
service technician!

Activate/Deactivate Dispenser

edge!
Deactivate
Activate
The printer is restarted. The main menu now contains the additional menu
DISPENSER PARA
tion:
[Tab. 1] Parameters in the menu DISPENSER PARA.
For more details on the listed parameters, see topic
meters
USER MANUAL
AP4.4 – AP5.4
Status 5004
Rewinder mat. tear
•
No printing material has been inserted, or the material's end was not fixed
to the rewinder. Attach the end to the rewinder and press the Online button.
•
The printing material is not stretched taut. Press the Online button.
•
Very small labels
•
Very rough backing paper
•
Backing paper much heavier than label
•
Labels stuck to backing paper
•
Backing paper perforated along label contour
Basic initialisation settings may only be changed by a qualified authorised
Only applies to the model AP 5.4 with internal rewinder and dispensing
SYSTEM PARAMETER > Periph. Device
Set
SYSTEM PARAMETER > Periph. Device
Call
, which holds the parameters required for dispenser opera-
Parameter Possible Settings
Dispenser Mode
Real 1:1 mode (default), batch mode, normal 1:1 mode
Dispensing Position
Set in millimeters (default: 0.0 mm)
Display Mode
Job rest quant. (default), Dispense counter
Dispense counter
Preset Amount (default: 0)
Application Mode
Safe Mode (default), Immediate Mode
Start Mode
Edge (default), Level low active
Start Source
Foot switch (default), Light barrier
, section "Operating the Parameter Menu".
Setup & Operation
to None
to Dispenser
Info- Printouts and Para-
20