Avaya P333T User Manual page 106

Chapter 6 CLI – Layer 2
• set port spantree cost
• set port security
• set cascading
• set inband vlan
• set vlan
• set port flowcontrol
• set port auto-
negotiation-
flowcontrol-
advertisement
• set trunk
• set leaky-vlan
• set spantree
• set spantree priority
• set autopartition
• set license
• set ppp authentication
incoming
• set ppp incoming
timeout
• set ppp baud-rate
• set web
aux-files-url
• set intelligent-multicast
• set intelligent-multicast
client-port-pruning
time
90
Sets the port spantree cost.
Enables MAC security on a range of
ports.
Sets switch cascading fault-monitoring
mode.
Sets the management VLAN ID.
Creates VLANs.
Sets the flow control mode of a port.
Sets the flowcontrol advertising
capabilities of a Gigabit port.
Sets the tagging mode of a port.
Enables/disables leaky-VLAN mode.
Enables/disables Spanning Tree
Protocol (STP).
Sets the STP Bridge priority level.
Enables or disables autopartitioning for
switches in a stack.
Enters a license number for the stack.
Defines the PPP authentication method.
Sets the time after which the system
automatically disconnects an idle PPP
incoming session.
Sets the baud rate used in PPP sessions.
Sets the location (URL/directory) of the
P330 Device Manager Help files.
Enables or disables the IP multicast
filtering application.
Sets the aging time for client ports.
Page 110
Page 111
Page 111
Page 111
Page 112
Page 112
Page 114
Page 114
Page 115
Page 115
Page 115
Page 116
Page 116
Page 117
Page 117
Page 117
Page 118
Page 118
Page 118
Avaya P333T User's Guide