Avaya P333T User Manual page 107

• set intelligent-multicast
router-port-pruning
time
• set intelligent-multicast
group-filtering-delay
time
• set secure mac
• set security mode
• set arp-aging-interval
• set arp-tx-interval
• set self-loop-discovery
Admin_Status
• set welcome message
• set allowed managers
enabled/disabled
• set allowed managers
IP
• set psu type
set logout
The set logout command is used to set the number of minutes until the system
automatically disconnects an idle session.
The syntax for this command is:
set logout <timeout>
timeout
Output Example:
To set the number of minutes until the system disconnects an idle session
Avaya P333T User's Guide
Sets the aging time for router ports.
Sets the time delay before a filter is
applied to a specific group.
Adds a unicast MAC address into the
CAM table of a secured port.
Enables or disables the stack's MAC
security.
Sets the ARP aging interval.
Sets the keep-alive interval.
Sets the IBM token ring discovery mode.
Sets a welcome message to appear after
a reboot.
Enables/disables the Allowed Managers
feature.
Used to add or remove an IP address
from the allowed managers table.
Sets the main power supply type (AC/
DC) of the module.
Number of minutes (0 to 999) until the system automatically
disconnects an idle session. Setting the value to 0 disables the
automatic disconnection of idle sessions (default is 15 minutes).
Chapter 6 CLI – Layer 2
Page 119
Page 119
Page 119
Page 120
Page 120
Page 120
Page 121
Page 121
Page 122
Page 122
Page 122
91