ResMed VPAP III, VPAP III ST, VPAP III ST-A Service Manual page 40

6 Connect the short brown wire to terminals 2a and L.
7 Take a 100 mm cable tie and fasten it around the receptacles on terminals 1, 1a, 2 and 2a. The
cable tie must be approximately half way down the recepticals.
8 The position of the cable tie knot must be located as shown below:
Position of cable tie knot
9 Reinstall the main wiring harness with switch into the bottom case.
Short brown wire connected to
terminals 2a and N
5 Replacing major subassemblies 39