Installer Setup - Honeywell VisionPRO 8000 Product Data

INSTALLER SETUP

Follow these steps to enter the Installer Setup:
1. Press and release the System Key.
FAN
ON Inside
AUTO
SYSTEM
EM HEAT
OFF
COOL
SCHED HOLD
2. Press and hold the two blank keys on either side of the
center blank key for approximately five seconds until
screen changes.
MON TUE WED
Inside
SYSTEM
EM HEAT
OFF
COOL
DONE
THU
Set To
Following
Schedule
A
M
CLOCK SCREE
M22426A
THU FRI SAT A A T SUN
Set To
Following
Schedule
PM
CANCEL
M19923
TM
VisionPRO 8000 Touchscreen Programmable Thermostat
3. Release the two blank keys when the screen on the
thermostat matches the screen below.
DONE
4. See screen below to review how the thermostat keys
are used during Installer Setup. See Tables 3-5 for the
Installer Setup Numbers and Settings.
INSTALLER
SETUP
NUMBER
MON
DONE O
PRESS TO EXIT
INSTALLER SETUP
5. Press the Done key to exit the Installer Setup screen.
15
M22442
ADVANCE TO NEXT
INSTALLER SETUP
CURRENT
SETTING
WED THU U FRI SAT A A T A SUN
CHANGE THE
CURRENT
SETTING
M22443
68-0280—01