Table of Contents
Advertisement
Install CR123A Lithium batteries as follows.
1. Remove the battery cap by turning it counterclockwise.
2. Check to ensure the o-ring is present. If not, replace it.
3. Observe polarity, as indicated on the outside of the battery
compartment, and insert two 3.0 Volt CR123A Lithium battery
into the battery compartment, minus (-) end first (Figure 2-1).
4. Replace battery cap by pushing and turning it clockwise.
Tighten it firmly to ensure a watertight seal.
2.1.2. EXAMINATION FOR OPERATION
Before getting started make sure to follow these steps:
1. Push ON-OFF button on the scopel.
2. Make sure that the luminance in ocular is present.
3. Observe the scene, and adjust the diopter and/or lens for
optimal image clarity.
2.1.3. SETTING
The working settings of OTS may be customized by means of a
Graphical User Interface (GUI) installed onto PC.
The Graphical User Interface (GUI) allows user to alter the behavior
of the device that includes defining the temperature based coloriza-
Figure 2-1. Install batteries
2-3
Advertisement
Table of Contents
