Table of Contents
Advertisement
tion parameters, configuring the device by defining which functions
are enabled or disabled, switching crosshair marks and defining
magnification parameters. The device settings can be modified in
realtime operation mode to simplify tailoring to your needs and then
saved to the device (see detail in OTS GUI Manual Guide).
Install the software into the PC from the CD/DVD supplied in the
package of each OTS. The USB Cable(1) is an interface link bet-
ween the thermal monocular and the external PC, and it accepts the
external power supply (2) at the same time (Figure 2-2).
IMPORTANT: When the unit is to be powered with external
sources, first make sure the batteries have been taken out.
Connect the monocular to a PC and to an external power supply
as follows:
1. Remove the batteries.
2. Remove the protective cap from the monocular output con-
nector socket.
3. Attach the PC cable to the output connector socket.
4. Attach the USB plug of the cable to a computer USB port.
5. Attach the power jack socket of the cable to a 6 VDC/ 1 A
power supply.
1
2
Switch the monocular on, start the auxiliary software and introduce
all the needed or desirable settings into it. Use the software as pro-
vided by the software manual.
2-4
Figure 2-2. OTS with USB Cable
Advertisement
Table of Contents
