Operation; Cleaning The Eyepiece - ATN NV-560 User Manual

• Tighten the three set screws to fit snugly to the NV-560's eyepiece
• You may need to focus the 35mm camera or video camera in combination with the NV-560 in
order to get the sharpest possible image.
• We suggest that you find an open space to work in. Focus the NV-560 so that the scene is
at its sharpest. For the best results you should disable the auto focus (if any) on either the
35-mm camera or the video camera and manually focus the 35-mm camera or the video
camera. Once the image is in sharp, then simply adjust the NV-560's front lens to change
the focus.
• An important part to remember is that you are not taking a picture of an object that is far away
from you, but you are actually taking a picture of a phosphorous screen of the NV-560 that is
only 2-3 inches away.

operATion

• Take the binoculars out of the case.
• Install the batteries into the housing with the polarity order as shown on the binoculars. Bat-
tery Type: 3 Volt Lithium, #CR123A
• Press the button marked -/O to turn unit on with the protective lens covers still attached to
the lenses. Do not turn unit on in the daytime without the protective lens caps on. You
should see a green glow in the eyepieces.
• Observe the scene, and adjust the diopters for the optimal image clarity.
• You may now enter a dark environment or simply shut the lights off in order to darken the
room.
• Next, remove the lens caps/daylight filters and observe the scene. You should readjust the
diopters for maximum clarity. Remember the focus range of the binocular is 20' to infinity.
• The unit will turn on and off automatically when you bring it to or take away from your eyes.
This is done by activating the proximity sensor. To activate the proximity sensor push the dig-
ital control marked "A". You will notice the green LED change to red when the sensor is on.
• In order to assure the proper functioning of the proximity sensor, make sure that the protective
glass surface of the sensor is always clean. Adjust the digital features as needed.
• To increase battery life the LED diodes will go off after 10 seconds.
• Take your time learning about your "smart" binoculars. It will take practice to properly use the
device. As you use these binoculars you will be able to improve your speed of focusing, as
well as sharpness of image.
• Have fun and enjoy.

cleAning The eyepiece

You may need to clean the eyepiece of the NV-560 from time to time in order to guarantee
top performance. When you receive your NV-560 you should check for dust on the eyepiece
of the unit. First you will need to remove the eyepiece. To remove the eyepiece you will need
to initially loosen 2 set screws that can be found on the base. Then unscrew the eyepiece
counter-clockwise to remove it.
NOTE: You do not have to remove the set screws completely, they are very small and easy to
misplace.
Screw
Camera adapter
Joint ring
4