Table of Contents
Advertisement
2.2. ASSEMBLY
2.2.1. EXTERNAL POWER SOURCE
WARNING
When the unit is to be powered with external sources, first make
sure the batteries have been taken out.
As an external power source, a standard network controller with
outer voltage of 6V and current of over 0.5A can be applied. To con-
nect an external source recommend to use a 6mm standard double-
pole socket in the way the positive contact is the central contact.
Use both the video or PC cable to connect an external 6 VDC/ 1 A
power supply to the OTS.
Connect an external power supply to the monocular as follows:
1. Remove the batteries.
2. Remove the protective cap from the monocular output con-
nector socket.
3. Attach the video/PC cable to the output connector socket.
4. Attach the power jack socket of the cable to a 6 VDC/ 1 A
power supply.
NOTES
1.
The external power supply plug must have a 6 mm OD con-
tact with center pin positive.
2.
Avoid a sudden removal of power source: use the power
button «ON/OFF» to turn the monocular off before you remove
batteries or disconnect external power supply.
3.
Replace the protective cap on the monocular output con-
nector socket after disconnecting the cable.
2.2.2. VIDEO OUTPUT
The OTS incorporates a sealed Connector used for video trans-
mission and to connect external power sources. Video Cable at-
taches the scope to the video facilities for video recording or video
2-5
Advertisement
Table of Contents
