Table of Contents
Advertisement
2. Please run your Hyper Terminal, and set up the console port like the following:
Bits per second: 115200
Data bits : 8
Parity: None
Stop bits: 1
Flow control: None
3. Change the IP Address by Hyper Terminal
The default IP address of IP01 is 192.168.1.100. Your network may have a different IP address
range such as 192.168.10.xx. In this situation, you can not access to IP01 by putty and browser if
you do not change the IP01 IP address. So you have to change the IP address for IP01 by Hyper
Terminal to make it in the same network segment as your LAN.
After you have accessed to IP01 by Hyper Terminal, please use the following command to change
the IP address for IP01.
root:~> ifconfig eth0 192.168.1.151(the IP address you want to set for IP01)
By this way, the IP address you set for IP01 is temporary, it will recover to the original default IP
address after rebooting. If you want to give a static and permanent IP address for IP01, you can try
to set it in web GUI, for detail steps please refer to chapter 3.
www.atcom.cn
9
Advertisement
Table of Contents
