Table of Contents
Advertisement
Model 3324 User Guide
•
Forward Delay Time: Forward Delay Time is the number of seconds a port waits before changing from its
STP learning and listening states to the forwarding state. The valid range is from 4-30.
Port Priority and Path Cost can be configured on each port. When finished click the apply icon.
•
Port Priority: Using Port Priority will make that port more or less likely to become the root port, the rage is
0-255,default setting is 128 the lowest number has the highest priority.
•
Path Cost: Specifies the path Cost of the port that switch uses to determine which port are the forwarding
ports the lowest number is forwarding ports, the rage is 1-65535 and default value base on IEEE802.1D
10Mb/s = 50-600
Port Sniffer
Port Sniffer is a method for monitoring traffic in switched networks. Traffic that goes in or out of the moni-
tored ports will be duplicated into the sniffer port.
•
Sniffer Mode: Press Space key to set sniffer mode: Disable\Rx\Tx\Both.
•
Monitoring Port: The sniffer port can be used to see all monitored port traffic. You can connect the sniffer
port to LAN analyzer or net x-ray.
•
Monitored Port: These are the ports you want to monitor. All monitored port traffic will be copied to the
sniffer port. You can select up to a maximum of 25 ports to monitor ports.
If you want to disable the function, you must select monitor port to none.
Administrator
3 • Configuring the 3324 for operation
100Mb/s = 10-60
1000Mb/s = 3-10
55
Advertisement
Table of Contents
