Smartnode 4400 Series Rear Panels; Smartnode 4400 Rear Panels; Port Descriptions - Patton electronics SmartNode 4400 Getting Started Manual

SmartNode 4400 Series Getting Started Guide

SmartNode 4400 Series rear panels

The SmartNode 4400 rear panel ports are shown in
ETH 0/1 ETH 0/1
ETH 0/1 ETH 0/1
Port
ETH 0/0 (WAN Ethernet 0/0 port) 10/100Base-Tx full-/half-duplex, RJ-45, auto detection and auto-
ETH 0/1 (LAN Ethernet 0/1 port) 10/100Base-Tx full-/half-duplex, RJ-45, auto detection and fall-
Console (RS-232 control port)
FXS Ports (4400/JS models)
SmartNode 4400 Series detailed description
0 /0
E T H
0 /1
E T H
ETH 0/0 ETH 0/0 Reset Reset Console Console
ETH 0/0 ETH 0/0 Reset Reset Console Console
Figure 3. SmartNode 4400 rear panels
Table 3. Port descriptions
MDI-X connects the unit to an Ethernet WAN device (for example,
a cable modem, DSL modem, or fiber modem).
back, connects the unit to an Ethernet LAN.
Used for service and maintenance, the Console port, an RS-232
RJ-45 connector with EIA-561 pinout, connects the router to a
serial terminal such as a PC or ASCII terminal (also called a dumb
terminal). Asynchronous default data rate 9600 bps, hardware
DSR and DTR signals for external modems are wired directly
together internally
For connection of up to 32 analog FXS devices (selectable for 12,
16, 24, or 32). Either a 50-pin or 64-pin RJ21X connector that
connects the router to an analog terminal (a telephone, for exam-
ple) FXO port. EuroPOTS support (ETSI EG201 188).
figure 3 and described in
Model SN4432
V
4 0
z )
0 -2 0 H
1 0
M P
0 -6
(5 1 A
rt s
P o
lc o
T e
5 0
o le
n s
C o
t
s e
R e
Telco ports
Console port
Ethernet ports
Telco Ports
Telco Ports
Description
1 • General information
table 3 on page 19.
100-240V 100-240V
(50-60 Hz) (50-60 Hz)
1 AMP 1 AMP
44xx/JS/UI
36-72V
1.6 AMP
44xx/JS/48
19