Table of Contents
Advertisement
Model 3324 User Guide
Note
Rate Control
Port 1-24 on the Model 3324 supports port-by-port ingress and egress rate control. For example, assume Port
1 is 10Mbps, users can set it's effective egress rate is 1Mbps, ingress rate is 500 kbps. The Model 3324 will be
performing flow control or back-pressure to confine the ingress rate to meet the specified rate.
•
Ingress: Type the port effective ingress rate. The valid range is 0–100. (Default is 100K) Entering 0 disables
rate control. (100 = 10 Mbps)
•
Egress: Type the port effective egress rate. The valid range is 0–100. (Default is 100K) Entering 0 disables
rate control. (100 = 10 Mbps)
Port Security
When a port is in security mode the port will be "locked" without the permission of address learning. Only the
incoming packets with MAC addresses already existing in the address table can be forwarded normally. Users
can disable the port from learning any new MAC addresses, and then use the static MAC addresses screen to
define a list of MAC addresses that can be use on the secure port. Enter the settings, then click the Apply but-
ton to make the changes to the Model 3324.
Duplex
User can set full-duplex or half-duplex mode of per port.
Administrator
The VDSL port will link down. After 20 seconds, the VDSL port will
link up again with the line rate (speed) you have configured.
Figure 18. VDSL Port Controls
Figure 19. Ethernet Port Controls
3 • Configuring the 3324 for operation
43
Advertisement
Table of Contents
