Changing The Ip Address - Patton electronics SmartNode 4830 Series Quick Start Manual

Open a Terminal connection to the SmartNode. Use the Terminal program included with most PC operat-
2.
ing systems (e.g. Hyper Terminal on Windows).
Type administrator as the login prompt and press the Enter key after the password prompt (do not type
3.
anything for the password). A prompt will appear consisting of the IP address and > character.
login:administrator
password:
172.16.40.1>
Following log in, the SmartNode is in operator execution mode (indicated by > character in the command
4.
line prompt). With the commands enable and configure, you enter the configuration mode.
172.16.40.1>enable
172.16.40.1#configure
172.16.40.1(cfg)#

3.3 Changing the IP address

Select the context IP mode to configure an IP interface.
1.
172.16.40.1(cfg)#context ip router
172.16.40.1(ctx-ip)[router]#
Set the IP address and network mask for the each IP interface (eth0, for example).
2.
For the examples in this guide, a private network (172.16.1) IP address is used.
Note
172.16.40.1(ctx-ip)[router]#interface eth0
172.16.40.1(if-ip)[eth0]#ipaddress 172.16.1.10 255.255.255.0
2002-10-29T00:09:40 : LOGINFO
2002-10-29T00:09:40 : LOGINFO
172.16.1.10(if-ip)[eth0]#
Make this modified configuration your new start-up configuration. On the next start-up the system will
3.
initialize itself using the modified configuration.
172.16.1.10 (if-ip)[eth0]#copy running-config startup-config
172.16.1.10 (if-ip)[eth0]#
SmartNode 4830 Series Quick Start Guide
: Link down on interface eth0.
: Link up on interface eth0.
5