Completing The Installation - Patton electronics 3096RC Getting Started Manual

G.shdsl tdm-digital access concentrator (t-dac)

Hide thumbs Also See for 3096RC:

Table of Contents

Model 3096RC T-DAC Getting Started Guide

Completing the installation

This section veriﬁes that the Model 3096RC is fully operational.

1. Verify that the green POWER LED is lit. If the POWER LED is ﬂashing green, refer to section

ysis"

on page 73.

2. Verify that the WAN LED illuminates, indicating that the Model 3096RC is synchronizing with the

T1/E1 signal.

3. Verify that after 5 seconds, the WAN LED begins ﬂashing, indicating that the Model 3096RC is satisﬁed

with the quality of the T1/E1 signal.

4. Verify that after 10 seconds, the WAN LED extinguishes, indicating that the Model 3096RC is satisﬁed

with the network signal and that the link is ready for use.

5. Verify that the green Ethernet LED is either ﬂashing (indicating link status is nominal for the front

Ethernet port) or on solid (indicating that link status is nominal for at least one of the Ethernet

backplane connections).

The Model 3096RC is operational.

Maintenance

5 • Troubleshooting and maintenance

"Fault anal-

Table of Contents