Patton electronics 3096RC Getting Started Manual page 68

Model 3096RC T-DAC Getting Started Guide
Note
6. There are two LEDs that indicate the status of the T-DAC 10/100 Ethernet port: a green LED indicates
link status and activity, and a yellow LED that indicates line speed. Verify that the green LED is either
flashing green (meaning that packets are being received at the Ethernet port) or solid green (meaning that
the link is valid but no packets are being received).
Congratulations! Your T-DAC is now installed. If you require further information about configuring your T-
DAC settings, refer to the DSL T-DAC Administrator's Reference Guide included on your Model 3096RC
CD-ROM.
Note
Completing the installation
If the T-DAC does not behave as described, the most likely cause is
that the T-DAC default settings are not compatible with the T1/E1
line. If this is the case, use the RS-232 CONFIG port to correct the
T-DAC settings. You will have to use the 3096RC Configuration
Menu pages to examine the configured T1/E1 link settings.
For information on activating and de-activating your Model 3096RC
T-DAC, refer to chapter 4,
3 • Configuring the T-DAC for operation
"Operation and shutdown" on page 69
68