Remote Ethernet Loop (Remetherloop); Remote Ethernet Loopback - Patton electronics 3096RC Getting Started Manual

Model 3096RC T-DAC Getting Started Guide
To deactivate the loop mode, use the
The port field should be highlighted green when the port returns to data mode.

Remote Ethernet loop (RemEtherLoop)

The remote Ethernet loop, initiated from the 3096RC, will place a remote CPE (3086 or 3201) in loop mode.
Under this condition, data sent by the 3096RC over the DSL link and destined to the Ethernet port of a Model
3086, or a Model 3201 CPE will be sent back to the 3096RC (see
sent over the DSL link and destined to the serial or T1/E1 port, will not be looped back to the 3096RC.
Ethernet
TDM
3086
To select remote Ethernet loop, do the following:
1. Go to the G.SHDSL page and find the port to be placed under loopback.
2. Locate the
Test Mode
3. Go to the bottom of the screen and click on the
loop will be highlighted in blue.
Basic G.SHDSL and T1/E1 test modes
Test Mode drop down menu, select
DSL
Figure 57. Remote Ethernet Loopback
drop down menu and select
5 • Troubleshooting and maintenance
OFF
figure 57). In the case of the Model 3086, data
.
RemEtherLoop
button. The port selected for remote Ethernet
Submit
and click on the
Submit
3096RC
button.
77