Patton electronics 3096RC Getting Started Manual page 74

Model 3096RC T-DAC Getting Started Guide
LED Location
ETHERNET
CLK SOURCE
CLK ERROR Front panel Yellow On solid Master Clock source has been lost and the 3096RC is using the
TEST MODE Front panel Green
Front Panel Green
a
WAN
DSL Front Panel Green
CONNECTION
(LEDs 1–16) b
READY Front panel
Fault analysis
Table 8. LED definitions (Continued)
Color Status
Front Green On solid
panel
Off
Front Green
On solid The 3096RC is set as the Master Clock source. No action rec-
panel
Flashing The 3096RC is set as the secondary clock source. No action
Off
Flashing Master Clock source and the Secondary Clock source have been
Off
On solid One or more G.SHDSL ports or T1/E1 ports is in test mode.
Flashing One or more of the G.SHDSL ports or the T1/E1 ports is in test
Off
On solid Indicates normal activity at each of the T1/E1/PRI links.
Single
Flash
Double
Flash
Off
On solid The ports are activated, linked, and operating normally.
Flashing One or more G.SHDSL ports have errors.
Off
Blue On
Off
5 • Troubleshooting and maintenance
Link status is nominal for the Ethernet port. No action recom-
mended.
A valid link has not been detected.
•
Verify that an Ethernet cable is plugged into the hub, switch,
•
or workstation and the Ethernet port of the Model 3096RC.
Verify that the hub, switch, or workstation is powered on.
•
Verify that the correct straight-through or cross-over cable is
•
being used, depending on whether you are connecting to a
workstation (PC), hub, or switch.
Replace the cable. If the problem still exists, contact Patton Tech-
•
nical Support to determine if the T-DAC should be replaced.
ommended.
recommended.
The 3096RC is set as the slave, getting its clock from the H.110
Bus. No action recommended.
secondary source for its clock.
lost and the 3096RC is using its internal crystal for its clock.
No clock errors currently detected.
No action recommended.
No action recommended.
mode and errors have been received.
None of the G.SHDSL ports is operating in test mode.
No action recommended.
No action recommended.
Indicates that the Model 3096RC is detecting the network, but
is unable to synchronize with it.
Indicates an error on any of the T1/E1/PRI links.
Indicates no T1/E1 links are in use.
No G.SHDSL ports have been configured to establish a link.
See Chapter 3,
"Configuring the T-DAC for operation"
page 35 to configure the G.SHDSL ports.
Card ready for removal from cPCI chassis.
Card not ready for removal from cPCI chassis.
Do not remove card from chassis.
Meaning
on
74