Patton electronics 2120 User Manual page 65

Default: 0 (Disabled)
Valid Entries: 0–65535
Note To activate the auto connection feature, this must be set to any
number (up to 65535) other than 0, "configure eia232
rawtcp_telnet confromlocena" must be set to YES, and a valid IP
address must be entered into "configure eia232 rawtcp_telnet
remip".
configure eia232 rawtcp_telnet keepaliveto X
Keepalive timeout <sec>
configure eia232 rawtcp_telnet locport X
Sets the TCP port number used to establish a connection with the serial
interface over the LAN.
Accessibility: READ/WRITE
Default: 404
Valid Entries: 0–65535
Note This TCP port number must be used as the TCP destination port
number by any device attempting to connect to the 2120's serial
interface over the LAN.
configure eia232 rawtcp_telnet remidlediscto X
Remote idle disconnect timeout <sec>
configure eia232 rawtcp_telnet remip X
Sets the destination IP address used when automatic connection
requests are sent to a remote device over the LAN.
Accessibility: READ/WRITE
Default: 1.1.1.8
Valid Entries: Any in IP address format
Note To activate the auto connection feature, "configure eia232
rawtcp_telnet confromlocena" must be set to YES and "configure
eia232 rawtcp_telnet conretryfreq" must be set to any number
(up to 65535) other than 0.
configure eia232 rawtcp_telnet remport X
Sets the destination TCP port number used when automatic connection
requests are sent to a remote device over the LAN.
Accessibility: READ/WRITE
Default: 23 (Telnet)
Valid Entries: 0–65535
Note This is used in conjunction with the automatic connection
feature.
configure eia232 rawtcp_telnet rempwd X
Sets/activates the password sent with automatic connection requests to
a remote device/application over the LAN.
65