BMTW-SVU02C-EN
Chapter 2
Viewing and Changing System Status
Information
You can display and change system status information using the BCU
operator-display view function. The view function enables you to:
View equipment status
•
Change setpoints
•
Override equipment controls
•
Note:
You may not have access to all of the tasks presented in this
guide. Your access privileges depend on your user profile. Con-
tact your supervisor for information.
View Screens
There are two types of view screens associated with the operator-display
view function: custom and standard screens. Standard screens are a part
of the Tracer Summit BCU operator-display software (see Figure 4 on
page 6). Custom screens are created from a screen template and custom-
ized for use at your site (see Figure 5 on page 7).
Note:
Standard screens are available with most, but not all, Tracer
Summit equipment (see Appendix B on page 67).
Custom Screens
If the Trane installer or programmer has selected custom screens for use
at the operator display, then a custom screen is the first screen that dis-
plays after you press the view button on the home screen. Custom screens
can be linked to standard screens by the use of a navigation button (see
Figure 5 on page 7).
Note:
Navigation of custom screens is not discussed in this guide.
Standard Screens
If the Trane installer or programmer has not selected custom screens for
use at the operator display, then standard screens are automatically dis-
played. The first standard screen to display after you press the View but-
ton is the View Equipment screen (see Figure 8 on page 10).
9
Need help?
Do you have a question about the BCU Operator Display and is the answer not in the manual?