The Back Panel - TP-Link TD-W8960N User Manual

TD-W8960N
Note:
1. If the ADSL LED is off, please check your Internet connection first. Refer to
the Router for more information about how to make Internet connection correctly. If you have
already made a right connection, please contact your
is available now.
2. If the Internet LED is off, please check your ADSL LED first. If your ADSL LED is also off,
please refer to Note
configuration. You may need to check this part of information with your ISP and make sure
everything have been input correctly. Refer to

1.3.2 The Back Panel

The Router's ports, where the cables are connected, and RESET button are located on the back
panel.
LINE: Connect to the Modem Port of Splitter or to the telephone line.
1, 2, 3, 4 (LAN): The ports (1, 2, 3, 4) connect the Router to the local PC(s).
RESET: There are two ways to reset the Router's factory defaults.
1) Use the Restore Default function on Management -> settings -> Restore Default page in
the router's Web-based Utility.
2) Use the Factory Default RESET button: With the Router powered on, use a pin to press and
hold the RESET button for at least 5 seconds. And the Router will reboot to its factory default
settings.
POWER: The Power plug is where you will connect the power adapter.
ON/OFF: The switch for the power.
Wireless Antennas: To receive and transmit the wireless data.
300Mbps Wireless N ADSL2+ Modem Router User Guide
1. If your ADSL LED is GREEN ON, please check your Internet
Figure 1-2
5
ISP to make sure
4.2 Device Info for more information.
2.3 Connecting
if your Internet service