TP-Link TD-W8960N User Manual page 62

TD-W8960N
Note:
1) If changing the Automatic Assigned Default Gateway from unselected to selected, you have
to reboot the Router to get the automatically assigned default gateway.
2) Default Gateway IP address should be specified since MER Interface is selected when you
select the Enable automatic Assigned Default Gateway check box.
4.4.10.2 Static Route
Choose "Advanced Setup" "Routing" "Static Route". You can see the Static Route screen,
this screen allows you to configure the static routes (shown in Figure 4-53). A static route is a
pre-determined path that network information must travel to reach a specific host or network.
To add static routing entries:
1. Click the Add button in Figure 4-53, and you will see the screen as shown in Figure 4-54.
2. Enter the following data:
Destination Network Address: The Destination Network Address is the address of the
network or host that you want to assign to a static route.
Subnet Mask: The Subnet Mask determines which portion of an IP Address is the network
portion, and which portion is the host portion.
300Mbps Wireless N ADSL2+ Modem Router User Guide
Figure 4-53
Figure 4-54
55