TP-Link TD-W8960N User Manual page 30

TD-W8960N
Note:
1) The following section adopts different VPI, VCI to introduce further configuration for the
different connection types, if you need to change the configuration of ATM PVC (VPI/VCI), you
should go to the previous section
2) ETH and ATM service can not coexist. If the ETH Interface had configured, you cannot
configure any other WAN service over the ATM Interface until the ETH Interface is deleted.
4.4.2.1 ATM-EoA-PPPoE
If your ISP provides a PPPoE connection and you need to use an ATM Interface, follow the steps
below to add a WAN service over a selected ATM interface:
1. Add a new ATM interface and select EoA option for DSL Link Type
2. Click the Add button on the screen Figure 4-7 and you will enter the next screen as shown in
Figure 4-8. Click Next.
3. Select the WAN service type in Figure 4-9. If your ISP provides a PPPoE connection, select
PPPoE option. You can create a service name for the Service Description or leave it the
default name. Click Next.
300Mbps Wireless N ADSL2+ Modem Router User Guide
(4.4.1 Layer2 Interface) to configure them again.
Figure 4-8
Figure 4-9
23
(4.4.1.1 ATM interface).