Remote Control - Dimplex DWF36 Owner's Manual

Operation
functions is cut off.
In " MANUAL " mode, the
fireplace's three levels of
operation are controlled by the
manual Control Buttons.
C. Manual Control Buttons
The manual Control Buttons
operate the fireplace levels
sequentially (from off): flames
only; to flames and low heat; to
flames and high heat.
The level is increased every time
the " I " button is pressed, and the
fireplace can be turned off at any
point by pressing the " O " button.
Resetting The
Temperature Cutoff
Switch
should the heater overheat, an
automatic switch will turn the
heater off and it will not come
back on without being reset.
The temperature cutoff switch
can be reset by unplugging the
unit, waiting five (5) minutes and
plugging the unit back in.
CAUTION: If you need to
continuously reset the heater,
unplug the unit and call
Dimplex customer service at
1-888-DImPLEX
(1-888-346-7539).
12
Figure 9
ON
Button
OFF
Button
Insulator Strip

Remote Control

The fireplace is supplied with a
radio frequency remote control.
This remote control has a range
of approximately 50 feet (15.25
m), it does not have to be pointed
at the fireplace and can pass
through most obstacles (including
walls). It is supplied with one
of hundreds of independent
frequencies to prevent
interference with other units.
!
NOTE:Before attempting any
operation with the remote, pull
the plastic insulator strip out from
between the remote casing and
battery cover (Figure 9).
Battery
Battery Cover
www.dimplex.com