Dimplex DWF36 Owner's Manual page 10

Fireplace Installation
7. Install the supplied wall
anchors on the marked
locations by placing a #2
Phillips screwdriver into the
recess of the anchor.
8. Press the anchor into the wall
in the desired marked position
while turning the anchor
clockwise until it is flush with
the wall.
9. Insert the wall anchor screws
through the wall bracket and
thread into the wall anchors.
Tighten the screw (Figure 3).
10. Install the remaining screws
through the bracket and into
the wall studs as required.
!
NOTE: At least two of
the mounting screws must be
installed into a wall stud.
11. remove the (2) screws
securing the firebox enclosure
cover. (Figure 4)
12. With the firebox tilted forward,
carefully pour and evenly
distribute the supplied glass
rock media on the front tray of
the firebox (Figure 5).
13. once complete, use the bare
end of the enclosed rake to
make sure the glass rock
media is level in the firebox.
(Figure 6)
10
Figure 4
Figure 5
WARNINg: When raking the
glass rocks be careful that the
rake does not scratch the mirror.
14. once the rocks are level, use
the foam end of the rake to
remove any dust left from
adding the glass rocks.
15. replace the enclosure cover.
16. Mount the unit on the wall as
shown (Figure 7).
www.dimplex.com