Page 1
For your safety, always comply with all warnings and safety instructions contained in this manual to prevent personal injury or property damage. To view the full line of Dimplex products, please visit www.dimplex.com 7212130100R05...
CAUTION: Procedures and techniques which, if not carefully followed, will result in damage to the equipment. WARNINg: Procedures and techniques which, if not carefully followed, will expose the user to the risk of fire, serious injury, or death. www.dimplex.com...
Welcome & Congratulations Thank you and congratulations for choosing to purchase an electric fireplace from Dimplex, the world leader in electric fireplaces. Please carefully read and save these instructions. CAUTION: read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
IMPORTANT INSTRUCTIONS overheat and cause a risk of fire. ⑮ Do not insert or allow foreign This heater is not intended for use objects to enter any ventilation with an extension cord. Plug the or exhaust opening as this may cord directly into an appropriate cause an electric shock or fire, or wall receptacle.
Page 6
· Consult the dealer or an experienced radio/Tv technician for help. operation is subject to the following two conditions: (1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device. www.dimplex.com...
Quick Reference guide before using the fireplace of your electric fireplace, verify: or require service contact • Are the circuit breakers customer service. for the unit on? The heater may emit a slight, • Are the light bulbs harmless odor when first loose? (To check, follow used.
WARNINg: The supplied volt circuit is required. A mounting components are dedicated circuit is preferred designed for use with Dimplex but not essential in all cases. fireplaces only. Improper use, A dedicated circuit will be or use for purposes other than...
Page 9
Fireplace Installation for installation Figure 2 select an appropriate location to mount the unit on a wall, above an electrical outlet. 610 mm (24") Access to the electrical outlet MINIMUM must be maintained. Ensure the installation meets the national and state/provincial electrical codes.
Page 10
Wall anchor Install the remaining screws through the bracket and into the wall studs as required. NOTE: At least two of screw the mounting screws must be installed into a wall stud. Wall remove the two (2) cover bracket www.dimplex.com...
Page 11
Fireplace Installation distribute the supplied glass plates from the wall mounting slots in the back of the rock media in the media tray firebox. (Figure 5) of the firebox (Figure 7). mount the unit on the wall, Hang the front glass as- so that the tabs on the wall sembly on the mounts of the bracket have been inserted...
Page 12
(Figure 8) Excess electrical cord can be inserted back into the bottom of the unit, into the cord storage area. www.dimplex.com...
When in “REMOTE” mode, continuously reset the heater, the fireplace's three levels of unplug the unit and call operation are controlled by the Dimplex customer service at ON and OFF buttons of the 1-888-DImPLEX remote control. (1-888-346-7539). In “OFF” mode, power to all...
10 second window to press any button on the remote Remote Control Initialization/ control. Reprogramming Press any button on the If the remote control or remote remote control within that 10 control receiver has been seconds. replaced, follow these steps to www.dimplex.com...
Page 15
Operation This will synchronize the remote control and receiver. NOTE: You will have only 10 seconds to perform this last step. Failure to do so will result in these steps needing to be followed again. Battery Replacement To replace the battery: slide battery cover open on the remote control (Figure 12).
To remove fingerprints or other marks, the Partially reflective Glass can be cleaned with a damp cloth. The Partially reflective Glass should be completely dried with a lint free cloth to prevent water spots. To prevent scratching, do not use abrasive cleaners. www.dimplex.com...
What Dimplex will do in the event of a defect? What this limited warranty covers and for how long...
Page 18
Warranty product or part without charge. If no EvEnT WILL DImPLEX, OR ITS Dimplex is unable to repair or replace oFFICErs, DIrECTors, or AGEnTs such product or part, or if repair or bE LIAbLE For ANY DIrECT LossEs, replacement is not commercially...
Need help?
Do you have a question about the DWF1215B and is the answer not in the manual?
Questions and answers