Dimplex DWF36 Owner's Manual page 13

Operation
Remote Control Initialization/
Reprogramming
If the hand held transmitter or
receiver board has been replaced,
follow these steps to initialize the
transmitter and receiver:
1. Ensure that power is supplied
through the main service
panel.
2. Turn main on/off switch to
on (Figure 8A).
3. Move the Three Position
switch to the " rEmoTE "
position (Figure 8B).
4. Press and hold the Manual
Control Button marked " I " for
five (5) seconds. After five (5)
seconds, there is a 10 second
window to press any button
on the remote control.
5. Press any button on the
remote control transmitter
within that 10 seconds.
This will synchronize the remote
control transmitter and receiver.
Remote Control Usage
The remote control operates the
fireplace levels sequentially (from
off): flames only; to flames and
low heat; to flames and high heat.
The level is increased every time
the ON button is pressed on the
remote control transmitter and the
fireplace can be turned off at any
point by pressing the oFF button.
Battery Replacement
To replace the battery:
1. slide battery cover open on
the hand held transmitter
(Figure 7).
2. Install one (1) 12-volt (A23)
battery in the battery holder.
3. Close the battery cover.
Battery must be recycled
or disposed of properly.
Check with your Local
Authority or retailer for recycling
advice in your area.
13