Viking E-1600A-TP-EWP Technical Practice page 7

Setting C - Silence Time Out
This feature selects the length of time that calls will remain connected without voice activ-
ity. Programmable in increments of 10 seconds up to a maximum of 90 seconds (Touch
Tones 1 - 9). To disable the silence time out, program 0 in this location. Use chart at the
far right. * Note: The factory default is 40 seconds.
Setting D - Dial Next Number on Ring No Answer
If enabled and a ring-no-answer is detected, the 1600A series
phone will dial the next programmed speed dial number, and con-
tinue to cycle through the emergency numbers until a call is com-
pleted. * Note: Factory set to redial if not answered after 7 rings.
Setting E - Dial Next Emergency Number on Busy
If enabled and a busy is detected, the 1600A series phone will dial the next pro-
grammed emergency speed dial number, and continue to cycle through the emer-
gency numbers until a call is completed. * Notes: This feature is enabled in the
factory default setting. If the busy signal is interrupted with a promotional mes-
sage, contact your central office to have it removed.
Setting F - Pulse Dialing Rate (Pulses per second)
The 1600A series phone is capable of different pulse dialing speeds.
* Note: The factory default setting is 10pps.
G. Voice Announcer/Miscellaneous Options
The 1600A series phones have a built-in non-volatile digital voice announcer that may be used to identify the location
of the emergency phone call. The 16 seconds of digital record time is recorded remotely from a Touch Tone phone.
Programming options are as follows:
Factory Default Setting: 0 + 0 + 1 + 2 + 1 + 0
Two Digit Announcement Delay {
Repeat Announcement Setting
Hang-up on Return to Dial Tone
Panasonic Mode
Lap Counter
Settings A and B - Announcement Delay
The 1600A series phone is factory set to automatically start playing the
voice announcement after it has determined the call has been answered.
Alternately, the announcement may be programmed to play after a pro-
grammed amount of time, from 1 to 99 seconds after dialing.
* Note: If the announcement delay time is used, you must allow enough time for the 1600A series phone to detect
ring-no-answer and busy signals when using the redial features. The factory default is set to play automatically.
Setting C - Repeat Announcement Option
The 1600A can be programmed to play the announcement from 1-9 times,
or to continuously repeat the announcement every 8 seconds until a
Q
Touch Tone is detected from the distant party. The call connected LED
will turn on automatically after the announcement has stopped repeating.
* Note: The factory default for the 1600A series phone is to play the voice announcement once (digit 1).
(memory location #17)
Dial: A + B + C + D + E + F + # + 1 + 7
Touch
Tone
Touch Tone Setting D
1 or 0 Disabled
2, 3, 4...9 Dials second number after
2, 3, 4...9 rings respectively*
Touch Tone
1
2
Touch Tone
1
2
Enter Settings Here:
A B C D
Touch Tone Setting A/B
00 Play automatically
01-99 1-99 seconds*
Touch Tone Setting C
0 Repeat every 8 secs
1-9 Repeat 1-9 times*
Silence
Time Out
0 Disabled
1 10 sec
2 20 sec
3 30 sec
4 40 sec*
5 50 sec
6 60 sec
7 70 sec
8 80 sec
9 90 sec
Setting E
Disabled
Enabled*
Setting F
10 pps*
20 pps
E F
#17
7