Identification Number - Viking E-1600A-TP-EWP Technical Practice

2. "INFO" Speed Dial Numbers
The information speed dial number programmed in location #07 is the telephone or extension number that is dialed
when the "INFO" button is first pressed. Additional information speed dial numbers will be dialed when there is no
answer and the next number redial feature is activated. The E-1600A-TP2-EWP phone will cycle through the pro-
grammed speed dial numbers until answered. To program, enter the desired speed dial number followed by the
location number (#07 - #09). To clear a speed dial location, simply enter the location (#07 - #09) alone.
3. Speed Dial Programming Examples
To Program the 1600A Series Phone...
...to store 555-1234 as the first emergency speed dial number
...to store a Touch Tone 9, a four second pause and then a pulse
dialed 333-4444 into the second "Info" speed dial memory position
...to clear the first emergency speed dial number
E. Identification Number
The Touch Tone I.D. number (up to 20 digits) is used by emergency personnel to identify the location of the caller and
is given out when the receiving party presses a Touch Tone Q. The security office can display the number using a
Touch Tone decoder. To program the I.D. number, enter the desired number followed by #20. Example: To store 333
as the I.D. number, enter: 3 3 3 # 2 0
F. Timing/Dialing Options
There are six positions in the timing/dialing options. To program these options, enter the six desired timing/dialing num-
bers followed by #18. The six available timing/dialing options are defined as follows:
Factory Default Setting: 2 + 3 + 4 + 7 + 2 + 1
Talk/Listen Delay
Call Length
Silence Time Out
Dial Next Number on Ring No Answer
Dial Next Number on Busy
Pulse Dial Speed
Setting A - Talk/Listen Delay
This feature selects switching time between talk and listen modes (VOX switching time).
Use chart at the right. * Note: The factory default is .2 seconds.
Setting B - Call Length Time Out
This feature selects the maximum length of time that calls can be connected.
Programmable in increments of 1 minute up to a maximum of 9 minutes (Touch Tones 1 -
9). Program 0 in this location to disable the call length time out. With the call length dis-
abled, the 1600A series phone must rely on a CPC signal, busy signal, silence or return to
dial tone to hang-up. Use chart at the right. * Note: The factory default is 3 minutes.
6
(E-1600A-TP2-EWP only) (memory locations #07 - #09)
(memory location #20)
(memory location #18)
Dial: A + B + C + D + E + F + # + 1 + 8
Step 1 -
Step 2 - Enter Digits:
See Section A
Enter Programming
Q
Enter Programming 9
Enter Programming
Enter Timing/Dialing Settings Here:
A B C
5 5 5 1 2 3 4 # 0 0
Q
7 6 3 3 3 4 4 4 4 # 0 8
# 0 0
D E F
#18
Touch Talk/Listen
Tone Delay
1 .1 sec
2 .2 sec *
3 .3 sec
4 .4 sec
5 .5 sec
6 .6 sec
7 .7 sec
8 .8 sec
9 .9 sec
Touch Call Length
Tone Time Out
0 Disabled
1 1 min
2 2 min
3 3 min*
4 4 min
5 5 min
6 6 min
7 7 min
8 8 min
9 9 min