Light Activated Operation - Venstar T2900 Owner's Manual

Setting up the Thermostat for

Light Activated Operation

A light sensor is provided on the thermostat for light activation. If the
thermostat is set up to be light activated, the thermostat will enter
Occupied 1 and blink the Occupied 1 icon when a light source is
detected. When the thermostat is set up to be light activated, the time
period programming for each day should be set to OFF (Section 6).
The thermostat must be in Program On mode for light activation to
have any effect. Page 17.3 explains how to adjust the light sensitivity
for this type of operation.
NOTE: Light activation does not work in Holiday mode (Section 21).
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
YES
Select YES if the
thermostat should be
Light Activated.
Select NO to allow only
Time Period Programming
(Section 6).
NO
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
The Light Sensor is located on
the top of the thermostat.
T2900
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
Setup
NO
42
Light Sensor
Page 17.2
MODE
MODE
17
Press
PROGRAM