Programmable/Non-Programmable Thermostat - Venstar T2900 Owner's Manual

Programmable or Non-Programmable
Thermostat
When the very simplest operation is desired, this thermostat
4
may be configured to be non-programmable, with or without
Auto-Changeover. Follow the step below.
If 'NO' is selected, the thermostat will lockout the Program On screen;
only the Off, Heat, Cool, and Auto screens may be accessed by
pressing the MODE button.
Select 'YES' if you would like your thermostat to be programmable,
then the Program mode will be accessible through the use of the
MODE button.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
YES
Select Yes if you would like
the thermostat to be program-
mable or No for non-program-
mable.
NO
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
Program On Setup
Y ES
1
Page 4.2
MODE
MODE
Press
PROGRAM