Calibrating The Temperature And Humidity Sensors - Venstar T2900 Owner's Manual

Calibrating the Temperature and Humidity Sensors

Under normal circumstances it will not be necessary to adjust the
calibration of the temperature and humidity sensors. If calibration is
required, please contact a trained HVAC technician to correctly
perform the following procedure.
Place the thermostat in the
MODE
OFF mode.
Press and hold the MODE
MODE
button. While holding the
MODE button, press and hold
the FAN button for 5 seconds.
FAN All icons will appear on the
display.
PRESS
THERMOSTAT SENSOR
Press the UP and DOWN
at the same time twice.
thermostat temperature will be
displayed and may be calibrated
using the UP or DOWN buttons.
TWICE
REMOTE SENSOR (RS1)
Press the MODE button once.
remote sensor temperature will be
MODE displayed and may be calibrated using the
UP or DOWN buttons. If a remote sensor
is not installed, a temperature reading of
-127 degrees will appear.
HUMIDITY SENSOR
Press the MODE button once.
relative humidity at the thermostat will be
MODE
displayed and may be calibrated using the
UP or DOWN buttons.
After calibration is complete, press the MODE button once to return to
normal operation.
12:00
Pm
Su
72
OFF
Program On
Am
18:88
Pm StartStop
SuMoTuWeThFrSa
DeHumidify
Service Filter
Pan UV Light
AUTO 188
OFFON
Unoccupied
123
Override
FanOn
buttons
The
72
The
Outside
74
The
35
Page 22.3
Setup
88
H
I
C
OOL
Outside
Remote
A H
UX EAT
L
O
88
CALIBRATE
CALIBRATE
CALIBRATE
22