Venstar T2900 Owner's Manual page 76

Phone Control of the
Programmable Output
To operate a MISC output using phone-based operation, program
advanced setup step #30 for Aux (below). This terminal is especially
useful for devices that can be energized via the phone.
Possible AUX scenarios:
1) Arm the alarm system in your home after you have left for
the day.
2) Turn on your spa before arriving home.
3) Turn on your interior lights while you're away.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
Press the MODE button repeatedly
MODE
until this setup screen appears.
I8:88 88
OFF Time = Temp =
Press the UP button three
t i m e s t o s e t t h e
pr ogr am mabl e out put
for Aux (phone-based
operation).
Programmable Output Polarity:
NC
NC = Normally Closed to operate
when programmed to be OFF
through the phone.
NO = Normally Open to operate
when programmed to be ON
through the phone.
NO
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
Aux
Setup
30
A
UX
Setup
31
NO
Page 14.7
MODE
MODE
14
Press
MODE
Press
PROGRAM