Venstar T2900 Owner's Manual page 79

Controlling or Reading the
Remote Temperature (RS
The thermostat may be programmed to only READ the remote sensor
or CONTROL to the remote sensor. Refer to advanced setup step
#37 below.
Read Only Sensor (RS1): If step #37 is set to only READ to the
remote sensor, the thermostat will not use this sensor for
temperature control. This sensor may be viewed by pressing the
OUTDOOR button on the thermostat and then pressing the
MODE button.
Control Sensor (RS1): If step #37 is set to CONTROL to the remote
sensor, the thermostat will ignore the reading of its internal
temperature sensor and only display the temperature reading
from the remote sensor. The degree icon on the thermostat will
blink once per second to indicate that a remote sensor reading is
being displayed.
Press the MODE button. While holding
MODE
the MODE, press the PROGRAM
button to enter Setup screens.
PROGRAM
15
Press the MODE button repeatedly
MODE
until this setup screen appears.
YES
Optional Remote Sensor:
YES = Control to Remote
Sensor RS1.
NO = Read only Remote
Sensor RS1.
NO
Press the PROGRAM button to leave the Setup screens. If no buttons are
pressed, the display will leave the setup screens after 30 seconds.
1
)
Note: Press the
button momentarily
to move through the
setup screens. Press
and hold the
button to move back-
wards through the
setup screens.
Setup
Y ES
37
Remote
Page 15.3
MODE
MODE
Press
PROGRAM