Backlight On/Off; Dial Pad And Button Beeps; Speakerphone/Microphone Sensitivity Adjustment - Toshiba IP EDGE User Manual

Backlight On/Off

Dial Pad and
Button Beeps
Speakerphone/
Microphone
Sensitivity
Adjustment
IPedge UG 11/11
Available on backlit telephones and backlit add-on module.
To change Backlight Settings
1. Press Hold+3+6+9 (simultaneously).
2. Press the Mic button.
3. Press Hold.
4. Use table below to choose preferred settings.
5. Press Hold Hold to save settings
Table 4 Backlight Settings
Button Input
1
FB1 2
3
FB2 1~30
FB1 is the lower left key, FB2 in the next up, FB3 is above FB2, and FB4
Note:
is above FB3.
IP telephones can emit a "beep" whenever a dial pad or feature button is pressed.
The "beeps" are On by default. Follow these steps to turn the "beeps" On or Off.
1. Press 3+6+9+Hold (simultaneously).
2. Press 0.
3. Press Hold.
4. Press Programmable Feature Button 1 (FB1) to toggle On/Off.
5. FB1, LED On: buttons beep.
6. FB1, LED Off: buttons do not beep.
7. Press Hold to set the option.
8. You must also go off-hook, then on-hook to exit the program mode.
When you are using the speakerphone, high ambient noise levels may cause the
party you are talking with to be to cut off frequently. If this happens, follow these
steps to lower the sensitivity of the microphone on a IP5000-series telephone. The
default is normal sensitivity.
1. Press 3+6+9+Hold (simultaneously).
2. Press 0.
3. Press Hold.
4. Press Programmable Feature Button 3 (FB3) to toggle On/Off.
5. FB3, LED On: Lower sensitivity
TOSHIBA
Meaning
Always Off
Always On
On-demand
Backlight
Timer [ x10 seconds]
Example: 1 = 10 seconds; 30 = 300 seconds.
IPedge
The Basics
21