Table of Contents
Advertisement
Connecting digital audio equipment
Connect the digital inputs of stereo amplifiers, mixers,
recorders and other digital equipment to this unit's digital
output connectors.
Connecting analog audio equipment
Connect the analog inputs of stereo amplifiers, mixers,
recorders and other analog equipment to this unit's
analog output connectors.
NOTE
Cables are not included with this unit.
•
Do not bundle RCA cables with power cords or speaker
•
cables. Doing so could noise or otherwise reduce sound
quality.
Using the parallel connector
To use an external controller for parallel control of
the unit, use the CONTROL I/O PARALLEL connector
(D-Sub 25-pin). For the pin assignments of the PARALLEL
connector, see "Using the parallel connector" on page 35.
Preparing the remote control
Inserting batteries
1 Open the cover on the back of the remote control.
2 Insert two AAA batteries with the correct ±
orientations.
3 Close the cover.
When to replace the batteries
Replace both batteries with new ones when the range
of the remote control becomes short or if the buttons
become unresponsive.
3 – Preparation
Precautions about using batteries
Misuse of batteries could cause them to leak, rupture or
otherwise be damaged. Please read and abide by the
precautions on the battery labels when using them. See
page 4 of this manual for additional precautions.
Precautions about using the remote
control
When using other devices controlled by infrared rays,
•
use of this remote control might operate these devices
by mistake.
Use the remote control within the following range.
•
Maximum operation distance
Directly in front: 7 meters
15° left or right: 7 meters
Remote control reception
settings
Operation of the unit using the remote control can be
disabled in order to prevent misoperation.
Use the
menu item to set whether or not the unit
15 IR
can be operated by remote control (default value:
NOTE
If remote control reception has been set to OFF, IR OFF
•
will appear on the display when any of the remote control
buttons are pushed.
The remote control reception setting (on/off) is saved
•
even if the unit's power is turned off.
Remote sensor
).
ON
17
TASCAM CD-6010
Advertisement
Table of Contents
