Table of Contents
Advertisement
Connecting analog audio equipment
Connect the analog inputs of stereo amplifiers, mixers,
recorders and other analog equipment to this unit's
analog output connectors.
NOTE
Cables are not included with this unit
Using parallel control (CD-500B only)
To use an external controller for parallel control of the
CD-500B, use the CONTROL I/O PARALLEL connector
(D-Sub 15-pin). For the pin assignments of the PARALLEL
connector, see "Using the parallel connector [CD-500B
only]" on page 32.
Preparing the remote control
Inserting batteries
1 Open the cover on the back of the remote control.
2 Insert two AAA batteries with the correct ±
orientations.
3 Close the cover.
NOTE
The batteries are not supplied for Taiwan.
When to replace the batteries
Replace both batteries with new ones when the range
of the remote control becomes short or if the buttons
become unresponsive.
Precautions about using batteries
Misuse of batteries could cause them to leak, rupture or
otherwise be damaged. Please read and abide by the
precautions on the battery labels when using them. See
page 4 of this manual for additional precautions.
3 – Preparation
Precautions about using the remote
control
When using other devices controlled by infrared rays,
•
use of this remote control might operate these devices
by mistake.
Use the remote control within the following range.
•
Remote sensor
15° 15°
Operation distance
Directly in front: Within 7 meters
15° left or right: Within 7 meters
Remote control reception
settings
Operation of the unit using the remote control can be
disabled in order to prevent misoperation.
Use the
menu item to set whether or not the unit
15 IR
can be operated by remote control (default value:
NOTE
If remote control reception has been set to
•
will appear on the display when any of the remote
OFF
control buttons are pushed.
The remote control reception setting (on/off ) is saved
•
even if the unit's power is turned off.
).
ON
,
OFF
IR
17
TASCAM CD-500/500B
Advertisement
Table of Contents
