Advanced Programming - Sunbeam EM7000 Instruction Booklet

Advanced Programming

Pre-infusion Programming
There are 3 programmable pre-infusion
settings to help achieve the perfect
extraction;
Infusion; a small amount of water is released
onto the tamped coffee, and then there is
a short infusion time before a steady flow
of water is released. Your espresso machine
comes with this selection as a factory setting.
Constant; delivers a constant water
temperature and flow from start to finish.
Progressive; small amounts of water are
released onto the tamped coffee prior to a
steady water flow.
1.Ensure the espresso machine is plugged in
and switch on at the power outlet.
Note: DO NOT press the POWER button on
the espresso machine.
2.PRESS and hold down both the MANUAL
and 1 CUP buttons.
3.While still holding down the MANUAL and
1 CUP buttons briefly PRESS the POWER
button and then release both the MANUAL
and 1 CUP buttons.
To indicate you have activated the
programmability of the pre-infusion
selections, a light on one of the buttons will
illuminate;
1 CUP = Infusion (Factory setting)
2 CUP = Progressive Pre-infusion
MANUAL = Constant Pre-infusion
This light will remain on for up to 5 seconds
before automatically returning to factory
settings if no action is taken. The espresso
machine will then power on.
10
4.PRESS and RELEASE one of the buttons
below depending on the required
temperature adjustment;
Constant = PRESS the MANUAL button
Infusion = PRESS the 1 CUP button
Progressive = PRESS the 2 CUP button
When the new pre-infusion program has
been selected the espresso machine will
beep twice.
5.The espresso machine will then
automatically power on.
Figure 6