Advanced Programming
In standby mode press
"PROGRAM" button
and get in to the
program mode.
(sequence:
showerhead outlet
water temperature,
steam flow rate, hot
water temperature,
pre-infusion, cleaning limit).
Keep pressing "PROGRAM" to choose the
desired program setting.
1. Showerhead outlet water temperature:
adjust the coffee thermoblock temperature
(range: 86 / 87 / 88 / 89 / 90 / 91 / 92
/ 93 / 94 / 95 / 96 / 97 / 98); press "-"
or "+" to change the setting and press
"PROGRAM" to save.
2. Steam flow rate:
adjust the steam
flow rate (range:
01-07, 01 is the
smallest and 07
is the biggest
setting); press "-" or
"+" to change the
setting and press
"PROGRAM" to save.
3. Pre-infusion
rate: adjust the
pre-infusion rate
(range: P1-P4);
press "-" or "+"
to change the
setting and press
"PROGRAM" to save.
4. Cleaning reminder:
set the water usage
limit for cleaning
reminder (range:
50L / 100L /
180L); press "-" or
"+" to change the
setting and press
Figure 27
"PROGRAM" to save.
5. Reset: reset all
setting back to
factory setting;
press "-" or "+"
to reset.
1 cup volume: Adjust
the 1 cup volume (LCD will display the time
counting, but the volume will be determined
by flow meter); press and hold "1 cup" button
for 3 seconds then the machine will start
brewing, when the coffee volume is enough,
press again "1 cup" button to save.
2 cup volume: Adjust the 1 cup volume
(LCD will display the time counting, but the
Figure 28
volume will be determined by flow meter);
press and hold "2 cup" button for 3 seconds
then the machine will start brewing, when
the coffee volume is enough, press again
"2 cup" button to save.
Figure 29
Figure 30
Figure 31
Figure 32
13