Advanced Programming Options - Sunbeam Espresso Vita EM6200 Instruction Booklet

Advanced programming options

Espresso Thermoblock Temperature
The water temperature of this espresso
machine has been calibrated to the precise
temperature of 92°C at the group head. The
temperature of the water at the group head
can be modified in increments of 2°C up and
down should it be desired.
To do this you need to follow the instructions
below:
1.Insert the power cord into a 230-240V AC
power outlet and switch the power 'ON'.
Note: Although the espresso machine is ON
at the power outlet ensure that the actual
espresso machine power is 'OFF'. Therefore
no lights will be illuminated on the espresso
machine control panel.
2.Press and hold down the 'MANUAL' button.
3.While still holding down the 'MANUAL'
button briefly press the 'POWER' button
and release all buttons.
Note: A series of beeps will indicate the
current setting.
Note: The 'MANUAL' button LED will light up
as will the 'SINGLE' and 'DOUBLE' buttons.
Note: The sequence of beeps will indicate the
current setting.
30
4.Press the 'SINGLE' button to decrease the
Espresso temperature setting or press the
'DOUBLE' button to increase the espresso
temperature setting. Please refer to the
chart below.
Espresso Temperature Programming
Setting
+3
+2
+1
0 (Factory Setting)
-1
-2
-3
5.Once you have selected the desired
temperature, press and hold the 'MANUAL'
button to save the new setting. A single
long beep will sound to indicate the new
setting has been saved. The espresso
machine will then turn on to 'READY
MODE'.
Remember: If you do not press the 'MANUAL'
button within 30 seconds the program will
return to the Factory Setting and the espresso
machine will then power on and begin
heating up.
Beep Sequence
3 Short Beeps
2 Short Beeps
1 Short Beep
1 Short Beep and 1 Long Beep
1 Long Beep
2 Long Beeps
3 Long Beeps