Tools - Schwinn A.C. Classic Service Manual

We recommend the following tools and lubes to properly assemble, maintain and repair all Schwinn

Tools

1. Torque wrench w/ 8mm Hex key socket: used to tighten the
crank bolts of crank arms to the specified torque.
2. Pedal wrench: Has 15mm and 9/16" wrench to tighten and loosen
pedals. 6mm hex key can be used on pedals with cage and toe
strap that come on the classic bike, but not on the pedals with spd
clips.
3. ISIS Crank puller: needed to take off right and left crank arms.
4. Bottom Bracket tool for removal and installation of ISIS BB. ISIS BB
should be tightened to 600-700 kgf*cm / 44-51 lbs*ft / 60-69Nm on
both right and left sides.
5. Adjustable wrench: used to tighten or loosen the pop pin
assembly from frame.
6. 17mm wrench: used to adjust the inside axle nuts closest to the
flywheel bearings.
7. 15mm wrench: used to loosen the outside axle nut on each side
of the flywheel bearings.
8. 14mm wrench: used to tighten the nuts of the seat bracket.
9. 5mm hex key and 13mm wrench used to tighten bolts on
stabilizer.
10. The pivot bolt for the brake will use an 8mm hex wrench and a
17mm wrench.
11. 2.5 mm Hex key: used to adjust chain tensioner bolts during
chain tightening, transport wheel nut and bolt and front nut of
the resistance assembly when centering brake pads.
12. 13mm wrench for resistance knob nylon nut.
13. 3mm Hex key: used for the screws of the water bottle cages.
14. Smart Release™ adjusting tool: high quality tool specifically
designed for use with the new adjustable Smart Release™
mechanism. (SR Models only).
15. 3mm Hex key: Install and remove the Console bracket and/
or Speed Sensor. Also attach the console bracket to the
handlebars. #2 philips screwdriver is required to remove
Console battery cover install/remove the console to the
bracket and power sensor to the brake mechanism.
16. 2.5mm Hex key to install/service the Power Sensor.
17. 4mm Hex key: All plastic hardware.
Tools
Lubricants
Note: To obtain the recommended lubricates contact Nautilus
Inc. at 1-800-NAUTILUS.
1. Schwinn Fit-Tech Silicone Spray: recommended for all
®
moving parts (e.g., handle bar post, seat post & slide, pop-
pins, resistance knob etc.)
2. Schwinn Equipment Polish: recommended on a damp cloth
®
when wiping down the frame after use.
3. Schwinn Citrus Chain Wax: recommend to lubricate
®
the chain through the rear hole in the chain guard as the
flywheel is rotating.
4. Schwinn® Quick Shot: recommended for the threads of
stabilizer bolts and pedals before tightening to crank arms.
4
Indoor Cycling bikes.
®